Zebra Technologies 3ULQWHUV 사용자 설명서

Print Mode Choices

Zebra XiIIIPlus Users Guide 

35

 

• If you do not have a cutter, go to 

• If you do have a cutter, feed the fanfold labels through the cutter.

Slide in the media guide so it just touches, but does not restrict, the edge of the 
labels.

Close the printhead lever.

When the ribbon has run out or must be changed, remove the used ribbon from the 
take-up spindle. 

• If the ribbon has run out, follow the instructions below.

• If the ribbon has not run out, open the printhead and tear or cut the ribbon as 

close to the ribbon take-up spindle as possible. Follow the instructions below.

Open the printhead. 

The illustration below and the table that follows show the ribbon take-up spindle. 
The inset shows the notches in the spindle.

Printhead lever

Media guide

Fanfold labels

The cutter blade is sharp. Do not touch the blade with your fingers.

Do not cut through the ribbon on the take-up spindle. Using the release knob 

allows you to slide the ribbon off the spindle. Cutting may damage the spindle.