Orbit Manufacturing 2000 사용자 설명서
Page 5 - 18
Operations
© GBC Films Group January 2001
Orbit™ 2000 Operation and Maintenance Manual
Plate holders
The plate holders keeps the paper sheet on the lower guiding plate to prevent it from jumping
over the second gate.
Positioning:
The machine has three hold-down fingers in total. The position of the middle one does not
change and is factory set. The position of the extreme two change with respect to the size of sheet, and is
adjusted to be about 10 mm distant from the edge of paper, after the screw ( h ) has been loosened. Be
sure to tighten the screw ( h ) after positioning the hold down fingers.
adjusted to be about 10 mm distant from the edge of paper, after the screw ( h ) has been loosened. Be
sure to tighten the screw ( h ) after positioning the hold down fingers.
10
10
Adjusting:
Pressure is adjusted by moving the holder ( i ) , which is held by screw ( j ). Follow the
procedure below.
1/
Loosen the screw ( h ).
2/
Insert one sheet of paper ( of the same
specific weight ) to be laminated.
3/
Adjust the holders so the finger ( k )
touches the paper without bending.
4/
Tighten the screw ( h ).
h
i
j
k
P re s s u re a re a
F e e d e r