Apple B2867757 사용자 설명서

When You Cannot Print

35

If the printing does not start, consult your service representative.

Printing does not start.

If the machine is operat-
ing in an extended wire-
less LAN, the receiver's 
MAC address may be 
preventing communica-
tion with the access 
point.

Check access point settings when in the 
infrastructure mode. Depending on the 
access point, client access may be limit-
ed by MAC address. Also, check there 
are no problems in transmission be-
tween access point and wired clients, 
and between access point and wireless 
clients.

Printing does not start.

The extended wireless 
LAN has not started.

Confirm the orange LED is lit, and the green 
LED is lit or blinks during transmission.

Printing does not start.

The login user name, 
login password, or driv-
er encryption key is 
invalid.

Check the login user name, login pass-
word, or driver encryption key.

Printing does not start.

Advanced encryption 
has been set using the Ex-
tended Security function.

Check the settings of the Extended Secu-
rity function with the administrator.

Data-in lamp does not 
blink or light up.

If the data-in lamp is un-
lit or not flashing even 
after performing [Print], 
the machine has not re-
ceived the data.

• When the machine is connected to a 

computer via a cable, check the com-
puter print port settings are correct. 
See “When the machine is connected 
to the computer using the interface 
cable”.

• When it is networked with a com-

puter, contact the administrator.

The status indicator of 
the printer is lit.

The cause is displayed 
on the display of the con-
trol panel.

Check the error message on the display 
panel and take required action. See p.30 
“When a Message Appears”.

“

Updating the des-

tination list... 

Please wait. Speci-

fied destina-

tion(s) or sender's 

name has been 

cleared.

” appears.

The destination list is be-
ing updated from the 
network using SmartDe-
viceMonitor for Admin.

Wait until the message disappears. Do 
not switch off the main power while this 
message is displayed. Depending on the 
number of destinations to be updated, 
there may be some delay before you can 
resume operation. Operations are not 
possible while this message is displayed.

 is dis-

abled.

A mechanical error 
might have occurred.

Contact your service representative. See 
“List / Test Print”, General Settings 
Guide.

Printing does not start 
when using the extended 
wireless LAN in Ad-hoc 
mode.

The correct Communica-
tion mode is not set.

Turn the main power off and back on. 
See “Turning On the Power”, About 
This Machine.

Or, change the settings for [System Set-
tings]

, [Interface Settings], and [Network]. 

See “Network Settings”, General Set-
tings Guide.