Toshiba M30 사용자 설명서
G-3
A
PPENDIX
G
*1 Factory-set default channels
*2
Refer to the sheet Approved Countries/Regions for use for the countries/regions
that in which these channels can be used.
When installing Wireless LAN Cards, the channel configuration is managed as
follows:
follows:
❖
❖
❖
❖
❖
For wireless clients that operate in a Wireless LAN Infrastructure, the Wireless
LAN Card will automatically start operation at the channel identified by the
Wireless LAN Access Point, When roaming between different access points
the station can dynamically switch to another channel if required.
LAN Card will automatically start operation at the channel identified by the
Wireless LAN Access Point, When roaming between different access points
the station can dynamically switch to another channel if required.
❖
❖
❖
❖
❖
For Wireless LAN Cards installed in Wireless clients that operating in a peer-
to-peer mode, the card will use the default channel 10.
to-peer mode, the card will use the default channel 10.
❖
❖
❖
❖
❖
In a Wireless LAN Access Point, the Wireless LAN card will use the factory-
set default channel (printed in bold), unless the LAN Administrator selected a
different channel when configuring the Wireless LAN Access Point device.
set default channel (printed in bold), unless the LAN Administrator selected a
different channel when configuring the Wireless LAN Access Point device.
Wireless IEEE 802.11 Channels Sets (Revision A)
Channel ID
Frequency Range 5150-5850 MHz
Note
36
5180
40
5200
44
5220
48
5240
52
5260
56
5280
60
5300
64
5320
149
5745
153
5765
157
5785
161
5805
Appendix G