Toshiba A60 사용자 설명서
8-6
User’s Manual
O
PTIONAL
D
EVICES
2. Please do not remove the SD card/MultiMediaCard/
Memory Stick from the SD card/MultiMediaCard/
Memory Stick slot while in Standby or in Hibernation
state. If you do, PC may become unstable or the data in
SD card/MultiMediaCard/Memory Stick may be lost.
Memory Stick slot while in Standby or in Hibernation
state. If you do, PC may become unstable or the data in
SD card/MultiMediaCard/Memory Stick may be lost.
3. Please do not turn off PC or go into Standby/Hibernation
,while computer is accessing the card; If you do, PC may
become unstable or you may lose data.
Memory expansion
You can install additional memory in the computer’s memory module to increase the
amount of RAM.
amount of RAM.
CAUTION: Only memory module with the following parts numbers can
be installed:
be installed:
256 MB
512MB
1024MB
512MB
1024MB
Installing memory module
To install a memory module, make sure the computer is in boot mode then:
section in Chapter 3.
CAUTIONS: 1. If you use the computer for a long time, the memory
modules will become hot. In this case, let the memory
modules cool to room temperature before you replace
them.
modules cool to room temperature before you replace
them.
2. Do not try to install a memory module with the
computer turned on or turned off in Standby and
Hibernation mode. You can damage the computer and
the memory module.
Hibernation mode. You can damage the computer and
the memory module.
3. If you install a memory module that is not compatible
with the computer, a beep will sound when you turn
on the power. If the module is installed in slot A, there
will be a long beep followed by a short beep. If the
module is in slot B, there will be a long beep followed
by two short beeps. In this case shut down the power
and remove the incompatible module.
on the power. If the module is installed in slot A, there
will be a long beep followed by a short beep. If the
module is in slot B, there will be a long beep followed
by two short beeps. In this case shut down the power
and remove the incompatible module.