IBM 150 사용자 설명서
150
RS/6000 43P 7043 Models 150 and 260 Handbook
5.3.1.3 Configuration Information
Information about the PCI adapters can be obtained by running the
Information about the PCI adapters can be obtained by running the
lscfg
command.
To determine how much memory you have in your machine, run the following
command:
command:
lsattr -El mem0
This will show the size of memory in your machine and how much usable
memory there is.
memory there is.
You can also see the size of the L2 cache installed in your system by using
the
the
lsattr
command:
lsattr -El L2cache0
5.3.2 PCI Adapter Configuration
If the required device drivers are installed, PCI adapters are configured
automatically at system restart or by using the
automatically at system restart or by using the
cfgmgr
command.
When you install the AIX operating system, it will query the PCI bus to identify
all AIX supported adapters. The installation process will install the required
device drivers and diagnostic support (if available), and the system will
automatically configure the PCI adapters.
all AIX supported adapters. The installation process will install the required
device drivers and diagnostic support (if available), and the system will
automatically configure the PCI adapters.
If you have a system installed and running, you can use
smit cfgmgr
. This
method will require you to put the AIX installation media in place (CD-ROM,
tape, and so forth) before configuring the adapters. The media will be used
only if the device drivers for your adapters are not currently installed.
tape, and so forth) before configuring the adapters. The media will be used
only if the device drivers for your adapters are not currently installed.
You can also manually install the device drives and diagnostics before
running
running
cfgmgr
or rebooting the system for automatic PCI adapter
configuration.
When using PCI adapters, the slot number is important. If you change an
adapter from slot A to slot B, the original adapter information for slot A will be
kept in a
adapter from slot A to slot B, the original adapter information for slot A will be
kept in a
defined
state; a new definition will be created for slot B, and a new
device will be configured.
5.3.2.1 Configuring Non-Graphic PCI Adapters
Configuring PCI adapters is very easy because they are actually configured
automatically when their driver software is installed and the
Configuring PCI adapters is very easy because they are actually configured
automatically when their driver software is installed and the
cfgmgr
command
is run.