Emerson ATCA-S201 사용자 설명서
RTM-ATCA-SXXX Installation
6806800H62B ATCA-S201ATCA-S201 Installation and Use Guide
125
Module Current
RTM-ATCA-
SXXX
SXXX
(No Disk)
RTM-ATCA-SXXX-2
(Two disk version)
+12 V (spin up < 100
sec)
sec)
0.55 A(6.6W)
2.05 A (25 W)
(staggered spin-up)
(staggered spin-up)
+12 V normal
operating
operating
0.55 A (6.6 W)
2.05 A (24.6 W)
+12 V (idle)
0.55 A (6.6 W)
1.55 A (18.6 W)
OFF STATE
LESS THAN
0.4 W
0.4 W
LESS THAN 0.4 W
12.3 Before You Install Or Remove The RTM
Boards may be damaged if improperly installed or handled. Please read and follow
the guidelines in this section to protect your equipment.
12.3.1 Observe ESD Precautions
Emerson strongly recommends that you use an antistatic wrist strap and a
conductive foam pad when installing or upgrading a system. Electronic
components, such as disk drives, computer boards, and memory modules, can be
extremely sensitive to electrostatic discharge (ESD). After removing the component
extremely sensitive to electrostatic discharge (ESD). After removing the component
from its protective wrapper or from the system, place the component flat on a
grounded, static-free surface (and, in the case of a board, component side up). Do
not slide the component over any surface.
If an ESD station is not available, you can avoid damage resulting from ESD by
wearing an antistatic wrist strap (available at electronics stores) that is attached to
wearing an antistatic wrist strap (available at electronics stores) that is attached to
an active electrical ground. Note that a system chassis may not be grounded if it is
unplugged.
12.3.2 Watch for Bent Pins or Other Damage
Bent pins or loose components can cause damage to the board, the backplane, or
other system components. Carefully inspect your board and the backplane for both
pin and component integrity before installation. Our suppliers take significant steps
to ensure there are no bent pins on the backplane or connector damage to the
to ensure there are no bent pins on the backplane or connector damage to the
boards prior to leaving our factory. Bent pins caused by improper installation or by
boards with damaged connectors could void the warranty for the backplane or
boards.
If a system contains one or more crushed pins, power off the system and contact
your local sales representative to schedule delivery of a replacement chassis
your local sales representative to schedule delivery of a replacement chassis
assembly.