Emerson ATCA-S201 사용자 설명서

ATCA‐S201 Installation

6806800H62B

ATCA‐S201 Installation and Use Guide

2.10.1 To Verify the Hardware Installation

1. After power is applied to the system, wait approximately 45 seconds for

firmware to initialize the board.

2. Inspect the LEDs on the front of the ATCA panel. When properly installed and

powered, the LEDs will illuminate as follows:

 ATCA Hot Swap LED

Off: Normal, default state

 ATCA Health status

Green-blinking: Healthy, OK

 ATCA Out of service (OOS)

Off: Normal, default state

3. (Optional). There are five Ethernet ports on the ATCA blade:

 1 management (on RTM)
 2 ATCA base ports (zone-2 connector)

 2 ATCA fabric ports (zone-2 connector)

If DHCP is running on the network, it is possible to immediately ping the
Ethernet ports on the ATCA module. Open a command line window on any

node, and attempt to ping the ATCA blade.

ok ping 192.168.1.xxx

Note1: Ping requires that you determine the IP address assigned to the blade. The
carrier blades MAC address assignments are registered with the IANA public section

of the IEEE Standards OUI (Organizational unique identifier) database. The Ethernet

ports for the blade can be identified by finding the IP address corresponding to the

following MAC address assignments:

MAC address OUI

00-11-0D-xx-xx-xx (hex)