Emerson ATCA-S201 사용자 설명서

RTM-ATCA-SXXX Overview

6806800H62B

ATCA‐S201 Installation and Use Guide

3.5 Command line configuration tool

This tool is available from either the RS232 console or a linux secure shell

connection. After successful login, the user may run an executable file “atca_blade”

located in the /web/cgi-bin directory. The tool provides the user with a simple menu
interface, to perform interactive parameter modifications. A sample session is

shown below.

#ssh 192.168.1.xxx -l root
root@192.168.1.xxx's password: root
Last login: Tue Nov 20 17:34:30 2007 from 192.168.1.xxx
# cd /web/cgi-bin
/web/cgi-bin # atca_blade

3.5.1 Change IP address of any Ethernet resource

The ATCA-S201 provides multiple Ethernet interfaces that host blades may use for

initial setup and configuration. These ports are identified with the Linux resource

labels shown in the table below

Table 7 Ethernet ports for chassis communications (base/fabric)

Linux interface identifier

description

/dev/eth0

Chassis Base port 0, 1Gb link

/dev/eth1

Chassis Base port 1, 1Gb link

/dev/eth2

RTM, Rear I/O management port.

/dev/eth3

Chassis fabric port 0, 10Gb XAUI link

/dev/eth4

Chassis fabric port 1, 10Gb XAUI link



Perform manual Interactive changes

After invoking the command line tool (atca_blade), the user can modify any of the

parameters within the functional groupings listed above. For example, select the “2.
Network Settings” group. The configuration tool will display the entire list

parameters in the group, along with their present values.

Main Page for CLI Interface
1. IPMI Settings (get_status)
2. Network Settings (set_network)
3. Hardware Raid Configuration (set_raid)
4. Logical Volume Mangager LVM2 Configuration (set_lvm2)
5. Manage Shares (set_shares)
6. smb Configuration (set_smb)
7. nfs Configuration (set_nfs)
8. iSCSI Configuration (set_iscsi)

9. Web gui enable (set_gui)

10. Allow Web and CLI at the same time (set_useroverride)

0. Exit
Enter choice [1-10], 0 to exit: [0]: 2

-------------- System Identification and TimeZone Active Settings -----
Hostname=[BladeHost]:
DomainName=[Emerson.com]