Furuno M51A 사용자 설명서

DLM 600W Series  

Isolated Remote Analog Interface Operation 

M51A Option 

2-9 

4. 

Program the other parameters to the desired limit values: VOLTAGE PROGRAMMING 
INPUT, Pin-9, and the CURRENT PROGRAMMING INPUT, Pin-10, with respect to 
Pin-12. 

 
5. 

Connect Pin-1, ANALOG-CONTROL, of the ISOLATED ANALOG INTERFACE 
connector to Pin-15. 

2.4.4 

2.4.5 

Resistance 

Programming of Output Voltage 

 
Setting up for resistance programming of the output voltage is as follows: 
 
1. 

Set Position-1, V, of the INTFC SETUP switch to OFF (down) for 0-5VDC programming 
range. 

 
2. 

Connect the external programming resistance, 0-5kΩ,  to the ISOLATED ANALOG 
INTERFACE connector, from Pin-21 to Pin-12. 

 
3. 

Connect a jumper from Pin-21 to Pin-9. 

 
4. 

Program the other parameters to the desired limit values: CURRENT PROGRAMMING 
INPUT, Pin-10, and the OVP PROGRAMMING INPUT, Pin-3, with respect to Pin-12. 

 
5. 

Connect Pin-1, ANALOG-CONTROL, of the ISOLATED ANALOG INTERFACE 
connector to Pin-15. 

 

Resistance 

Programming of Output Current 

 
Setting up for resistance programming of the output current is as follows: 
 
1. 

Set Position-2, I, of the INTFC SETUP switch to OFF (down) for 0-5VDC programming 
range. 

 
2. 

Connect the external programming resistance, 0-5kΩ,  to the ISOLATED ANALOG 
INTERFACE connector, from Pin-22 to Pin-12. 
 

3. 

Connect a jumper from Pin-22 to Pin-10. 
 

4. 

Program the other parameters to the desired limit values: VOLTAGE PROGRAMMING 
INPUT, Pin-9, and the OVP PROGRAMMING INPUT, Pin-3, with respect to Pin-12. 

5. 

Connect Pin-1, ANALOG-CONTROL, of the ISOLATED ANALOG INTERFACE 
connector to Pin-15.