Furman Sound AC-215 사용자 설명서

AC-215 / AC-210 E AC Power Conditioner

- 3 -

2. Your unit should not be used near water – for 

example, near a bathtub, washbowl, kitchen 

sink, laundry tub, in a wet basement, near a 

swimming pool, etc.

3. Do not place your unit near heat sources 

such as radiators, heat registers, stoves or 

other appliances that produce heat.

4. The unit should only be connected to a 120 

VAC, 60Hz, 15 Amp [230 VAC and10 Amp for 

the AC-210 E] grounded electrical outlet. Do 

not defeat the ground or change polarization of 

the power plug.

5. Route the power cord and other cables so 

that they are not likely to be walked on, tripped 

over, or stressed. Pay particular attention to 

the condition of the cords and cables at the 

plugs, and the point where they exit your unit. 

To prevent risk of fi re or injury, damaged cords 

and cables should be replaced immediately.

6. Clean your unit with a damp cloth only. Do 

not use solvents or abrasive cleaners. Never 

pour liquid on or into the unit.

7. Your unit should be serviced by qualifi ed 

service personnel when:

• The power supply cord or the plug 

has been frayed, kinked, or cut.

• Objects have fallen or liquid has 

spilled into the unit.

• The unit has been exposed to rain or 

other moisture.

• The unit does not appear to operate 

normally or exhibits a marked change 

in performance.

• The unit has been dropped, or the 

enclosure damaged.

8. Your unit requires that a safety ground be 

present for proper operation. Any attempt 

to operate the unit without a safety ground 

is considered improper operation and could 

invalidate the warranty.

9. Do not attempt to service yourunit beyond 

what is described in this manual. All other 

servicing should be referred to qualifi ed service 

personnel.

While the AC power delivered by today’s 

overworked and outdated power grid may be 

adequate for typical lighting and consumer 

products, it is well below the level of quality 

needed for connecting sensitive audio and 

video equipment. With the average investment 

in home theater equipment steadily rising, it’s 

more important than ever to purify or clean 

your incoming AC power. 

Furman’s Series Multi-Stage Protection Plus 

(SMP+) circuitry incorporates Linear Filtering 

Technology (LiFT) to insure that fl at screen 

televisions, projectors, processors, and other 

sensitive audio/video components are fed 

linearly-fi ltered AC power. This dramatically 

reduces noise, ensuring consistent, peak 

performance from your equipment. The result 

is better performance, a better quality picture, 

and less wear on your components.

Another feature unique to Furman’s SMP+ 

circuit is automatic Extreme Voltage Shutdown 

(EVS) with a TVZ MOV. Extreme voltages are 

statistically the most common, damaging AC 

event. The Extreme Voltage Shutdown circuit 

automatically turns off the AC-215 / AC-210 E 

when it is fed 137 volts [270VAC for the AC-210 

E or 260VAC for the AC-210 E UK] or higher, 

protecting itself and connected equipment from 

the extreme voltage. Only Furman offers this 

advanced degree of protection.