American Power Conversion 100 VAC 사용자 설명서

990-7096 Rev. 2 

6

 

 

1.  If the rack holes are not 10-32 

threaded, first attach the backing plate 
supplied (870-1148) 

Œ to the rack. 

2.  Support the UPS from the front and 

back.  Insert the four (4) ornamental 
screws supplied with the UPS 
through the mounting brackets and 
into the top and bottom holes in the 
U-space as shown for the Four-Post 
Rack.  Screw them into the threaded 
holes of the backing plate. 

Removing the UPS from the Rack 

 

Due to the weight of the UPS, two people are required to remove it from the rack. 

1.  Remove the front panel bezel:  Face the front of the UPS, and, using both hands, insert each 

index finger behind the lip of the curved section of the front panel bezel and pull towards you.   

2.  Unscrew the four ornamental screws (two screws on each mounting bracket). 

3.  Position one person in front of the rack and the second person either behind or on one side of 

the UPS for additional support.   

4.  Using the battery tray handle to support the front of the unit, slide the UPS partially out of the 

rack. 

5.  Supporting the UPS from the bottom or rear of the unit, slide the UPS fully out of the rack.   

 

 

The UPS is shipped without its battery connected and the front panel bezel installed (it 
is packaged separately within the main box).  You must connect the battery and install 
the plastic front panel bezel before the installation is complete. 

 

 

1.  Facing the front of the UPS, locate the battery cable (in the 

center of the unit) and remove the tape to expose the cable 
connector. 

2.  Locate the UPS battery connector 

Œ which is to the right of the 

battery tray 

 and recessed.  Connect the battery cable 

connector to the UPS connector.  Press firmly to ensure that the 
connection is tight.  You will hear a “snap” when the connector 
is properly seated.  Also, as a visual indication, the back of the 
connector should be recessed (~0.64 cm) from the sheet metal 

Œ



Ž

Œ

Œ