AEG 1000 사용자 설명서

 
 

37 

Before you connect the load segments to the UPS, please make 
sure that the actual power output on the type plate is larger than 
or equal to the sum of the load power consumption. 
Connect the desired load segments to the output jacks of your 
UPS. Use the load segment connection cords that come with the 
device. Pay attention to the division of the output plugs (also see 
Chapter 5.2 on pg. 29). Connect critical load segments that 
require a constant power supply preferably to the output jacks with 
a permanent power supply. The manageable output power circuits 
divide the load segments. To remove the load segment power 
cords, press the red button below the corresponding output outlet. 
Leave your load segments switched off for the time being. If 
further load segment connections are required, please contact 
your retail dealer. 

Removal by pushing
the red push button

 

Fig. 18

:

  Load segment power circuit 

i

 

In the case of a common service cabinet (electric
circuits as well as power supply and UPS voltage),
mark each circuit with the corresponding supply
(mains power line or UPS). 

The segment load on the UPS should never exceed the specified 
nominal load of the device. If the device is overloaded for any 
reason, the red LED will light up to indicate the problem and a 
warning sound will be heard. The load segments connected will 
continue to be supplied with power, depending on how much of an 
overload there is, for a certain time, but the load must be reduced 
accordingly as soon as possible. 
If you ignore the “device overload” warning, this can result in a 
complete loss of the UPS functions! 
Also try to avoid short-term device overloads, which can occur, 
for example, if you connect a laser printer or a laser fax machine.