AEG 1000 사용자 설명서

 
 

55 

There are several different interfaces available to control the UPS 
and conveniently read out status messages and measurements. 
The interface log is designed to be used with “CompuWatch”, the 
shutdown and UPS management software from AEG. Use the 
RS232 or USB communication cable that comes with the device to 
connect your UPS to a PC. 

i

 

The USB and the RS232 communication interface 
rule each another out, i.e. either USB or RS232. 
Pin allocation of the RS232 Sub-D9 jack: 
2 = TxD; 3 = RxD; 5 = GND 

There is a cover on the rear panel of the UPS (see no. 12 on on 
page 31); remove it to install additional, optionally available 
communication components, e.g.: 
Relay card:  Plug-in card with status messages, realized via 
potential-free relay contacts (opener or closer) 
Relay PRO card: As above, but with programmable pin 
allocation, connection via terminal, additional option of remote 
On/Off 
SNMP card: Plug-in card for the direct integration of the UPS 
into the Ethernet network via RJ45 (TCP/IP) 
SNMP PRO card:  As above, but with the additional option of 
connecting and managing an external sensor system  
For details, please refer to the descriptions that come with each 
option. Additional cards are in preparation. 

i

 

The communication slot can be used in parallel to 
the RS232 or USB interface.