Panasonic A4P Series 사용자 설명서

100

Only applicable to the system which uses absolute encoder. You can clear the alarm and multi-turn data of
the absolute encoder.

Clearing of absolute encoder starts

Clearing finishes

Error occurs

(

 When non-applicable encoder is

)

  connected

Clearing of absolute encoder 

completes

<Remarks>
Don't disconnect the console from the driver between                     to                     .
Should the connector is pulled out, insert it again and repeat the procedures from the beginning.

<Notice>
If an error code No. 40 is shown on the console immediately after purchase, clear the absolute encoder 
through the console.

Press       five time after pressing       , to setup auxiliary function mode, 

then with              , make a display to

Press       to call for 

                  EXECUTION DISPLAY of

Then keep pressing       until the display of Console (LED) 

changes to 

“      ” increases by 

pressing        (approx. 5sec) 

as the left fig. shows.

When you have cleared the absolute encoder, press       to return to                                  .

A incremental encoder or any 
unsupported encoder other than an 
absolute encoder may be connected. 
Reset the power supply and clear the 
error.