Philips ADAT-4 사용자 설명서

 

An external power supply conforming to the specifications listed in the following “Power Supply 
Specifications” section must be used to guarantee that published SoundPals performance 
figures are met.  Any power supply meeting these specifications will supply adequate power for a 
single SoundPals module.  Although the specification is written for power supplies running from 
AC line inputs, DC (battery) sources may be used if they meet all of the listed requirements. 

For CE compliance, the power supply that you use must comply with the following requirements: 

•  Low Voltage Directive 73/23/EEC 

•  EMC Directive 89/336/EEC 

•  EMC Directive 93/68/EEC 

•  The connector locking ring must be tight. 

For portable SoundPals power sources, sealed lead-acid, nickel cadmium or alkaline primary 
batteries may be used.  However, the maximum voltage must not exceed 8.6 volts, and a 
minimum of 5.6 volts is required for normal operation.  Maximum current drain will be 215mA.   

The following specifications must be met over all anticipated operating conditions including AC 
power line range, temperature range, etc. 

 

Output voltage 

5.6 V minimum (measured at trough of ripple) at 215 mA constant current. 

 

8.6 V maximum (measured at peak of ripple) at 140 mA  constant current. 

Ripple voltage 

2 V p-p at 700 mA constant current. 

 

400 mV p-p at 700 mA constant current with external 2200 

µ

F capacitor. 

Connector Switchcraft 

761K 

with 

center positive, sleeve negative. 

In addition to the GPS-supplied universal power supply, the following power supplies meet the 
SoundPals requirements: 
 

Stancor 

STA-4860 

120V AC, 60 Hz  

Stancor  

STAF-0797F 

220V AC, 50 Hz with European wall plug (CE compliant). 

Elpac  

MI2007 

95-250V AC, 47-63 Hz with IEC inlet (line cord required).  Will power up to six 
units (CE compliant).