NEC NP-M352WS 사용자 설명서

❶ Troubleshooting

This section helps you resolve problems you may encounter while setting up or using the projector.

Off

The main power is off

–

Blinking light

Blue

0�5 sec On,

0�5 sec Off

The projector is getting ready to turn on�

Wait for a moment�

2�5 sec On,

0�5 sec Off

Off Timer is enabled�

 –

Steady light

Blue

The projector is turned on�

–

Orange

The projector is [NETWORK STANDBY] mode or 

sleep mode*�

–

Red

[NORMAL] is selected for [STANDBY MODE]

–

Off

Power on or Standby ([NORMAL] or [NETWORK 

STANDBY] for [STANDBY MODE])

–

Blinking light

Red

1  cycle  (0�5  sec 

On, 2�5 sec Off)

Lamp cover error or lamp housing error

Replace the lamp cover or lamp housing correctly�

2  cycle  (0�5  sec 

On, 0�5 sec Off)

Temperature error

The projector is overheated� Move the projector to 

a cooler location�

3  cycle  (0�5  sec 

On, 0�5 sec Off)

Power error

Power unit is not working properly� Contact your 

dealer�

4  cycle  (0�5  sec 

On, 0�5 sec Off)

Fan error

Fans will not work correctly�

6  cycle  (0�5  sec 

On, 0�5 sec Off)

Lamp error

Lamp fails to light� Wait a full minute and then turn 

on again�

Orange 1  cycle  (0�5  sec 

On, 2�5 sec Off)

Network conflict 

Both the built-in wired LAN and the wireless LAN cannot 

be connected to the same network at the same time�

To use both built-in wired LAN and wireless LAN at the 

same time, connect them to different networks�

Green

Re-firing  the  lamp  (The  projector  is  cooling 

down�)

The projector is re-firing�

Wait for a moment�

Steady light

Green

The  projector  is  in  [NORMAL]  mode  or  sleep 

mode�

–

Orange

CONTROL PANEL LOCK is on�

You  have  pressed  cabinet  button  when  Control 

Panel Lock is on�

CONTROL ID error

Remote  control  ID  and  projector  ID  are  not 

matched�

Off

Normal

–

Blinking light

Red

Lamp has reached its end of life� Lamp replace-

ment message will be displayed�

Replace the lamp�

Steady light

Red

Lamp has been used beyond its limit� The projector 

will not turn on until the lamp is replaced�

Replace the lamp�

Green

[ECO MODE] is set to [AUTO ECO], [NORMAL] 

or [ECO]

–

* For more information on "sleep mode", see page

If the temperature inside the projector rises too high, the over-temperature protector will automatically turn off the lamp
with the STATUS indicator blinking (2-cycle On and Off.)
Should this happen, do the following:
•  Unplug the power cord after the cooling fans stop.
•  Move the projector to a cooler location if the room where you are presenting is particularly too warm.
•  Clean the vents if they are clogged with dust.
•  Wait about 60 minutes until the inside of the projector becomes cool enough.