Festool 574354 사용자 설명서

The guide rail attachment is used to connect the 
router to a Festool guide rail system for making 
guided straight cuts with the rail controlling the 
router position. 

Before assembling the guide rail attachment, 
adjust the Guide Rail Gibs on the guide block. 
These keep the guide block (see bottom left 
image) straight on the rail. 

Place the guide block on the rib of the guide 
rail. 

Tighten the two adjustment screws until the 
block fits snuggly to the rib without wiggling, 
but still moves freely. 

 

Supplemental User’s Manual 

19 

Install the optional Guide Rail Baseplate on the 
router (see page 11). 
The elevated foot 
plate 
compensates for 
the thickness of 
the guide rail to 
keep the router 
flat. 

Insert the two 
guide rods through the guide block and into the 
clamping bar. Make sure the rods stick out from 
the clamping bar slightly, as shown. 

Tighten the two guide rod thumbscrews. 

 

Insert the guide rods through the eyelets in the router base. 

Place the router on the guide rail, and adjust the router in or 
out as needed. Make sure the router bit does not cut the 
guide rail or splinter guard. 

 

Note: The black rubber splinter guard on the guide 
rail is used for sawing operations, and should not 
be used for routing operations. Make sure the 
router bit does not cut into the splinter guard. 

Tighten the guide rod clamping knob on the router. 

 

Fine tune the router’s position by turning the fine adjustment 
dial on the guide block.  

When the lateral position is correct, tighten the guide block 
clamping knob. 

Before starting the router, make sure that all clamping knobs 
and devices are secured. 

Operate the router as described in the applicable section(s) 
under 

 beginning on page 12.