Runco PL-50XA 사용자 설명서
Runco PlasmaWall Owner’s Operating Manual
31
PRE
L
IMINAR
Y
5. Click the Advanced button and click the
Monitor tab on the dialog box. Set the
vertical frequency to 60Hz and click OK.
vertical frequency to 60Hz and click OK.
4.4
Using the On-Screen
Menus
Using the On-Screen
Menus
Press the MENU button on either the remote control or the DHD Controller front panel to
display the Main Menu, shown below. To select a menu item, use the UP and DOWN
buttons on either the remote control or the DHD Controller front panel to highlight it. Press
ENTER to confirm your selection.
display the Main Menu, shown below. To select a menu item, use the UP and DOWN
buttons on either the remote control or the DHD Controller front panel to highlight it. Press
ENTER to confirm your selection.
The PlasmaWall OSD menus are arranged hierarchically, as shown in Figure 4-2.
Depending on the selected input source and signal characteristics, some menu options
may not be available.
Depending on the selected input source and signal characteristics, some menu options
may not be available.
1. The native resolution of the PlasmaWall is 1365 x 768. Other
horizontal or vertical resolutions may be scaled upward or
downward to fit the display.
downward to fit the display.
2. With most computers, you can get the best picture at 1024 x
768 @ 60Hz.
3. For best results when using a computer, set the input on the
DHD Controller to HD Pass Thru 1 or HD Pass Thru 2, depending
on which RGB/HD input you are using.
on which RGB/HD input you are using.
4. The PlasmaWall supports 36-bit color (68.7 billion possible
colors).
To prevent image retention (burn) on your display,
ALWAYS use a
screen saver and set it to the shortest possible time.
Note
WARNING