Hoshizaki FD-1001MAH(-C) 사용자 설명서

41

This icemaker must be maintained individually, referring to the instruction manual and 
labels provided with the icemaker. The schedule below is a guideline. More frequent 
maintenance, however, may be required depending on water quality, the icemaker's 
environment, and local sanitation regulations. 
Consult with your local distributor about inspection and maintenance service. To obtain 
the name and phone number of your local distributor, visit www.hoshizaki.com or call 
Hoshizaki Technical Support at 1-800-33-1940 in the USA.

1. Only qualified service technicians should attempt to service or maintain this 

icemaker.

. Disconnect power before performing maintenance.

Every  
Weeks

Air Filter(s)

Inspect. Wash with warm water and neutral cleaner if dirty. 

Monthly

External Water 
Filters

Check for proper pressure and change if necessary.

Icemaker and 
Dispenser Unit/
Storage Bin 
Exterior

Wipe down with clean, soft cloth. Use a damp cloth containing a neutral 
cleaner to wipe off oil or dirt build up. Clean any chlorine staining (rust 
colored spots) using a non-abrasive cleaner like Zud or Bon Ami.

Infrared Sensor 
Lens; Underside of 
Icemaker and Top 
Kits; Bin Door and 
Snout (if applicable)

Wipe down with clean cloth and warm water.

Every 6 
Months

Icemaker and 
Dispenser Unit/
Storage Bin

Clean and sanitize per the cleaning and sanitizing instructions provided in 
this manual.

Evaporator 
Condensate Drain 
Pan and Gear 
Motor Drain Pan

Wipe down with clean cloth and warm water. Slowly pour one cup of 
sanitizing solution (prepare as outlined in the sanitizing instructions in 
this manual) into the evaporator condensate drain pan. Be careful not to 
overflow the pan. This solution will flow down to the gear motor drain pan 
and out the drain line to sanitize these areas. Repeat with a cup of clean 
water to rinse.

Icemaker and 
Dispenser Unit/
Storage Bin Drains

Check to make sure they are clear.

Yearly

Inlet Water Valve 
and Drain Valve

Close the water supply line shut-off valve and drain the water system. 
Clean the inlet water valve screen and clean and inspect the drain valve.

Water Hoses

Inspect the water hoses and clean/replace if necessary.

Condenser 
(air-cooled and 
remote air-cooled)

Inspect. Clean if necessary by using a brush or vacuum cleaner.

Icemaker

Inspect for oil spots, loose components, fasteners, and wires.

Upper Bearing 
(extruding head)

Check for wear using .0" round stock or pin gauge. Replace both upper 
bearing and lower bearing if wear exceeds factory recommendations. See 
the Service Manual for details.