Cabletron Systems T1 사용자 설명서

 

This chapter describes the features of the WPIM-T1/DDS. It also briefly 
explains the WAN protocols supported by the WPIM-T1/DDS. 

Some steps for successful operation of this device are:

 

Install the WPIM-T1/DDS in a Wide Area Network host platform. 
Refer to 

appropriate host manual (i.e., the Cabletron Systems 

 

 for other installation and 

troubleshooting procedures.

 

Access Local Management. Refer to the appropriate host platform 
Local Management User’s Guide for instructions on setting up and 
accessing Local Management.

 

Select the service desired, T1 or DDS, using Network Tools.

 

Once the desired service has been chosen, refer to the appropriate 
chapter in this document for setup information.

Due to the automation of setup features, it is strongly recommended to 
use the Graphical User Interface, QuickSET, to fully configure the device. 
QuickSET is the desired method for configuring the WPIM-T1/DDS, 
after using Local Management to choose T1 or DDS service. Check the 
Release Notes for the availability of QuickSET for configuration. Use 
Local Management, described in this manual, if QuickSET is not 
available.

 

The device in which the WPIM-T1/DDS is to be installed may 
be referred to as the host platform in this documentation.