Cabletron Systems 7C04 사용자 설명서

Monitoring Hub Performance

2-13

Using the 7C0x SmartSwitch Hub View

The Bridge Application Display — available only for devices which have been 
configured (via Local Management) to operate as traditional bridges — allows 
you to view each bridge interface according to bridging status and statistics; it 
also provides access to the Bridge and Bridge Port menus (

), from which 

you can launch the Bridge View application, change the port display form, view a 
list of source addresses communicating through a selected interface, and enable 
or disable a selected interface. This is the default display mode for devices 
configured for traditional bridging.

Figure 2-9. The Bridge Application Display and Menus

For more information about the Bridge View application, see Chapter 6, Using the 
7C0x Bridge View

; for more information about viewing source addresses, see 

; and for more information on 

enabling and disabling a bridge interface, see Enabling and Disabling Bridge 
Ports

. Port display forms are described below.

You can display the following information for each bridging interface:

Displays the port’s current bridging status:

•

 (forwarding) — the port is on-line and ready to forward packets from 

one network segment to another. Note that this is the default display for ports 
which are administratively enabled but not connected.