Cabletron Systems 9E312 사용자 설명서
Filtering Database
3-23
9E312/9E423 Module Bridging
Source Port
Indicates the port number on which the address entry was first detected. A
question mark (?) indicates that the address entry was not a learned entry, but
Port Filtering information applies to it (i.e., the entry is a created Permanent,
Dynamic, or Static entry and has corresponding filtering information).
question mark (?) indicates that the address entry was not a learned entry, but
Port Filtering information applies to it (i.e., the entry is a created Permanent,
Dynamic, or Static entry and has corresponding filtering information).
Receive Port
Indicates the number of the port on which a frame must be received in order for
the entry’s Port Filtering information to apply. This field will remain blank unless
a Filtering Database entry has first been defined as being Permanent, Static, or
Dynamic.
the entry’s Port Filtering information to apply. This field will remain blank unless
a Filtering Database entry has first been defined as being Permanent, Static, or
Dynamic.
An asterisk (*) indicates that the receive port is promiscuous, and applies to all
ports of the bridge (assuming no conflicting entry applies). You can change the
receive port, as described in the following section.
receive port, as described in the following section.
Port Filtering
Indicates the action that will take place at each bridge port when it receives
frames from the selected address entry. This field will remain blank unless a
Filtering Database entry has first been defined as being Permanent, Static, or
Dynamic.
frames from the selected address entry. This field will remain blank unless a
Filtering Database entry has first been defined as being Permanent, Static, or
Dynamic.
A green arrow indicates that the frames received from the address will be
forwarded to the port’s associated segment (
forwarded to the port’s associated segment (
). A red circle indicates that
frames will be filtered (blocked) from the port’s associated segment (
). You
can change the Port Filtering action, as described in the next section. (Note that
port filtering is scrollable among all the potential ports; however, only two
consecutive ports can be viewed simultaneously.)
port filtering is scrollable among all the potential ports; however, only two
consecutive ports can be viewed simultaneously.)
Configuring the Filtering Database
You can configure the Filtering Database by:
•
Altering the Ageing Time for Dynamic and Learned entries.
•
Changing the type of entry with the Type buttons.
•
Changing the Receive port for the filter.
•
Changing the Port Filtering action at each bridge port.
•
Adding or deleting individual Filtering Database entries.
•
Clearing all Permanent, Static, or Dynamic entries from the Filtering Database.
Note that although configuration changes will appear in the window, no action
actually takes place in the bridge’s Filtering Database until you click on the OK
button in the bottom right of the window. This saves the new configuration.
actually takes place in the bridge’s Filtering Database until you click on the OK
button in the bottom right of the window. This saves the new configuration.