IBM 12.1(22)EA6 사용자 설명서
18-9
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 18 Configuring SPAN and RSPAN
Configuring SPAN
This example shows how to set up a SPAN session, session 1, for monitoring source port traffic to a
destination port. First, any existing SPAN configuration for session 1 is cleared, and then bidirectional
traffic is mirrored from source port 17 to destination port 18.
destination port. First, any existing SPAN configuration for session 1 is cleared, and then bidirectional
traffic is mirrored from source port 17 to destination port 18.
Switch(config)# no monitor session 1
Switch(config)# monitor session 1 source interface gigabitethernet0/17
Switch(config)# monitor session 1 destination interface gigabitethernet0/18
encapsulation dot1q
Switch(config)# end
Creating a SPAN Session and Enabling Ingress Traffic
Beginning in privileged EXEC mode, follow these steps to create a SPAN session, to specify the source
and destination ports, and to enable ingress traffic on the destination port for a network security device
(such as a Cisco IDS Sensor Appliance):
and destination ports, and to enable ingress traffic on the destination port for a network security device
(such as a Cisco IDS Sensor Appliance):
Step 4
monitor session session_number
destination interface interface-id
[encapsulation {dot1q}]
destination interface interface-id
[encapsulation {dot1q}]
Specify the SPAN session and the destination port (monitoring port).
For session_number, specify 1.
For interface-id, specify the destination port. Valid interfaces include
physical interfaces.
physical interfaces.
(Optional) Specify the encapsulation header for outgoing packets. If
not specified, packets are sent in native form.
not specified, packets are sent in native form.
•
dot1q—Use IEEE 802.1Q encapsulation.
Step 5
end
Return to privileged EXEC mode.
Step 6
show monitor [session session_number]
Verify your entries.
Step 7
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Command
Purpose
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
no monitor session {session_number | all |
local | remote}
local | remote}
Clear any existing SPAN configuration for the session.
For session_number, specify 1.
Specify all to remove all SPAN sessions, local to remove all local
sessions, or remote to remove all remote SPAN sessions.
sessions, or remote to remove all remote SPAN sessions.