IBM 12.1(22)EA6 사용자 설명서

2-6

Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide

24R9746

Chapter 2 Using the Command-Line Interface

Using Editing Features

Recalling Commands

To recall commands from the history buffer, perform one of the actions listed in

Table 2-4

Disabling the Command History Feature

The command history feature is automatically enabled.

To disable the feature during the current terminal session, enter the terminal no history privileged
EXEC command.

To disable command history for the line, enter the no history line configuration command.

Using Editing Features

This section describes the editing features that can help you manipulate the command line. It contains
these sections:

•

Enabling and Disabling Editing Features, page 2-6

•

Editing Commands through Keystrokes, page 2-7

•

Editing Command Lines that Wrap, page 2-8

Enabling and Disabling Editing Features

Although enhanced editing mode is automatically enabled, you can disable it.

To re-enable the enhanced editing mode for the current terminal session, enter this command in
privileged EXEC mode:

Switch# terminal editing

Table 2-4

Recalling Commands

Action

The arrow keys function only on ANSI-compatible terminals such as VT100s.

Result

Press Ctrl-P or the up arrow key.

Recall commands in the history buffer, beginning with the most recent command.
Repeat the key sequence to recall successively older commands.

Press Ctrl-N or the down arrow key.

Return to more recent commands in the history buffer after recalling commands
with Ctrl-P or the up arrow key. Repeat the key sequence to recall successively
more recent commands.

show history

While in privileged EXEC mode, list the last several commands that you just
entered. The number of commands that appear is determined by the setting of the
terminal history global configuration command and history line configuration
command.