Cabletron Systems 2H23-50R 사용자 설명서
High Speed Interface Configuration Screen (2H23-50R Only)
2H23-50R/2H33-37R User’s Guide
5-51
5.13.2
Configuring an FE-100TX
In normal operation, a slot (5 or 6) with an FE-100TX interface
automatically establishes a link with the device at the other end of the
segment and no user setup is required.
automatically establishes a link with the device at the other end of the
segment and no user setup is required.
and
provide instructions for manually configuring the port
with an FE-100TX installed.
5.13.2.1 Setting the FE-100TX Operational Mode
Use the Desired Oper. Mode field to set the active technology. This field
steps between Auto-Negotiation, 10Base-T, 10Base-TFD (full duplex),
100Base-TX, and 100Base-TXFD (full duplex). If Auto-Negotiation is
selected, the FE-100TX automatically sets the active technology. To
manually set the active technology through Local Management, proceed
as follows:
steps between Auto-Negotiation, 10Base-T, 10Base-TFD (full duplex),
100Base-TX, and 100Base-TXFD (full duplex). If Auto-Negotiation is
selected, the FE-100TX automatically sets the active technology. To
manually set the active technology through Local Management, proceed
as follows:
1.
Use the arrow keys to highlight the Desired Oper. Mode field.
2.
Use the SPACE bar to select the desired mode. Press ENTER. If any
mode other than Auto-Negotiation is selected, the port only operates
in the chosen mode and Auto-Negotiation is disabled.
mode other than Auto-Negotiation is selected, the port only operates
in the chosen mode and Auto-Negotiation is disabled.
3.
Use the arrow keys to highlight the SAVE command. Press ENTER.
The message “SAVED OK” displays and Local Management saves
the changes to memory. The selected mode is displayed in both the
Desired Operational Mode field and the Current Operational Mode
field.
The message “SAVED OK” displays and Local Management saves
the changes to memory. The selected mode is displayed in both the
Desired Operational Mode field and the Current Operational Mode
field.
5.13.2.2 Setting the FE-100TX Advertised Ability
In normal operation, a port (5 or 6) with an FE-100TX auto-negotiates to
the highest speed possible. Under some circumstances, the Network
Administrator may want the port to advertise only some of the available
modes. The Advertised Ability field provides the capability to set those
modes. This field steps to 10Base-T, 10Base-TFD (full duplex),
100Base-TX, and 100Base-TXFD (full duplex). To set the advertised
ability, proceed as follows:
the highest speed possible. Under some circumstances, the Network
Administrator may want the port to advertise only some of the available
modes. The Advertised Ability field provides the capability to set those
modes. This field steps to 10Base-T, 10Base-TFD (full duplex),
100Base-TX, and 100Base-TXFD (full duplex). To set the advertised
ability, proceed as follows:
1.
Use the arrow keys to highlight the Advertised Ability field.
2.
Use the SPACE bar to select the desired mode.