Cabletron Systems 3H08-04 사용자 설명서

Chapter 6: Adding/Swapping Modules

1. Make sure the ATX is powered off.

2. Remove the network connections from the module you are going to 

replace.

3. Loosen the screws at each end of the front panel of the interface 

module you are going to replace.

4. Remove the installed interface module by pulling gently, but firmly, 

on the ears at the ends of the module’s front panel.

5. Gently slide the switch module into the plastic guides in the module 

slot until it is completely inserted. Push the module firmly into place, 
as far as it will go, to fully engage the connectors at the back of the 
module with the backplane at the rear of the ATX chassis.

6. Tighten the screws on each side of the switch module’s front panel.

7. Power on the ATX, and check the switch module LED power on 

sequence as described in Chapter 2, Connecting to the Network.

8. Make the connections to the network as described in Chapter 2.

When swapping identical modules, it is recommended that you remove 
power to the ATX. However, the switch module you are replacing must be 
taken offlline first, as described below:

1. Take the switch module to be replaced offline, either by pressing the 

OFFLINE button on the switch module front panel, or by using the 
Local Console Manager 

offline 

command.

2. Remove power from the ATX.

3. Remove the network connections from the switch module. Note the 

ports to which the network connections attach.

4. Loosen the screws at each end of the front panel of the switch module 

to be replaced.

5. Remove the installed switch module by pulling gently, but firmly, on 

the ears at the ends of the module’s front panel.