Cabletron Systems 6H129-08 사용자 설명서

The 6H12X-08 can be installed in any of the five slots that are available in 
the 6C105 chassis. To install a module, proceed as follows:

Locate the antistatic wrist strap shipped with the 6C105 chassis. 
Attach the strap to your wrist and plug the cable from the antistatic 
wrist strap into the ESD grounding receptacle at the upper right corner 
of the 6C105.

Remove the blank panel covering the slot where the module will be 
installed. All other slots must remain covered to ensure proper 
circulation and cooling. (Save the blank plate in the event you need to 
remove the module.)

Locate the slot guides that line up with the number of the slot in which 
the module will be installed. Install the module in the chassis by 
aligning the module circuit card between the upper and lower metal 
rail guides of the desired slot, sliding it into the chassis, and locking 
down the top and bottom plastic locking tabs, as shown in 

Ensure that the module slides in straight and properly engages the 
backplane connectors.

Failure to observe static safety precautions could cause 
damage to the 6H12X-08. Follow static safety handling rules 
and use the antistatic wrist strap provided with the 6C105 
chassis. Do not cut the non-conductive bag to remove the 
module. Damage could result from sharp objects contacting the 
board or components.

To prevent damaging the backplane connectors in the following 
step, ensure that the module slides in straight and properly 
engages the backplane connectors. 

In the following step, ensure that the top plastic locking tab 
lines up with the desired slot number located on the front panel 
of the chassis. Refer to 

.