Juniper Networks EX3200 사용자 설명서
3.
From the computer, start your asynchronous terminal emulation application
(such as Microsoft Windows HyperTerminal) and select the COM port to which
the modem is connected (for example, COM1).
(such as Microsoft Windows HyperTerminal) and select the COM port to which
the modem is connected (for example, COM1).
4.
Configure the port settings shown in Table 33 on page 157.
Table 33: Port Settings
Value
Port Settings
115200
Bits per second
8
Data bits
None
Parity
1
Stop bits
None
Flow control
5.
In the HyperTerminal window, type
at
. Press Enter.
The modem sends an OK response to verify that it can communicate successfully
with the COM port on your desktop or notebook computer.
with the COM port on your desktop or notebook computer.
6.
To configure the modem to answer a call on the first ring, type
ats0=1
at the
prompt. Press Enter.
7.
To configure the modem to accept modem-control DTR signals, type
at&d1
at
the prompt. Press Enter.
8.
To disable flow control on the modem, type
at&k0
at the prompt. Press Enter.
9.
To set the fixed serial port speed on the modem, type
at&b1
at the prompt. Press
Enter.
NOTE: You must set the serial port to the fixed speed so that the modem will not
adjust the serial port speed to the negotiated line speed.
adjust the serial port speed to the negotiated line speed.
10.
To save the new modem settings, type
at&w0
at the prompt. Press Enter.
The modem sends an OK message. The modem is now ready to be connected
to the switch.
to the switch.
Connecting the Modem to the Console Port
The console port on every EX Series switch accepts a cable with an RJ-45 connector.
Figure 64 on page 158 shows the RJ-45 connector of the Ethernet cable supplied with
the switch.
Figure 64 on page 158 shows the RJ-45 connector of the Ethernet cable supplied with
the switch.
Connecting the Modem to the Console Port
■
157
Chapter 11: Connecting the Switch