Juniper Networks EX3200 사용자 설명서
Chapter 12
Performing Initial Configuration
■
■
■
■
Connecting and Configuring an EX Series Switch (CLI Procedure)
There are two ways to connect and configure an EX Series switch: one method is
through the console using the CLI and the other is using the J-Web interface. This
topic describes the CLI procedure.
through the console using the CLI and the other is using the J-Web interface. This
topic describes the CLI procedure.
Before you begin connecting and configuring an EX Series switch through the console
using the CLI:
using the CLI:
■
Set the following parameter values in the console server or PC:
■
Baud Rate—9600
■
Flow Control—None
■
Data—8
■
Parity—None
■
Stop Bits—1
■
DCD State—Disregard
■
To run the
ezsetup
script, the switch must have the factory default configuration.
If you have configured anything on the switch and want to run
ezsetup
, revert
to the factory default configuration. See Reverting to the Default Factory
Configuration for the EX Series Switch.
Configuration for the EX Series Switch.
Connecting and Configuring an EX Series Switch (CLI Procedure)
■
161