Cisco Systems 3560 사용자 설명서
46-10
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
Chapter 46 Configuring Fallback Bridging
Monitoring and Maintaining Fallback Bridging
This example shows how to disable spanning tree on a port in bridge group 10:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# bridge group 10 spanning-disabled
Monitoring and Maintaining Fallback Bridging
To monitor and maintain the network, use one or more of the privileged EXEC commands in
For information about the fields in these displays, see the Cisco IOS Bridging and IBM Networking
Command Reference, Volume 1 of 2, Release 12.2 from the Cisco.com page under Documentation >
Cisco IOS Software > 12.2 Mainline > Command References.
Command Reference, Volume 1 of 2, Release 12.2 from the Cisco.com page under Documentation >
Cisco IOS Software > 12.2 Mainline > Command References.
Table 46-2
Commands for Monitoring and Maintaining Fallback Bridging
Command
Purpose
clear bridge bridge-group
Removes any learned entries from the forwarding
database.
database.
show bridge [bridge-group] group
Displays details about the bridge group.
show bridge [bridge-group] [interface-id |
mac-address | verbose]
mac-address | verbose]
Displays MAC addresses learned in the bridge group.