Cisco Systems 3560 사용자 설명서

After you configure online diagnostics, you can start diagnostic tests or display the test results. You can 
also see which tests are configured for each switch and what diagnostic tests have already run. 

These sections describe how to run online diagnostic tests after they have been configured:

After you configure diagnostic tests to run on the switch or on individual switches, you can use start to 
begin a diagnostic test. 

Beginning in global configuration mode, use this command to start an online diagnostic test:

This example shows how to start a diagnostic test on a specific switch:

Switch# diagnostic start test 1

Switch#

06:27:50: %DIAG-6-TEST_RUNNING: Running TestPortAsicStackPortLoopback{ID=1} ...

06:27:51: %DIAG-6-TEST_OK: TestPortAsicStackPortLoopback{ID=1} has completed

successfully Switch#

You can display the online diagnostic tests that are configured for specific switches and check the results 
of the tests using the show commands. 

To display the diagnostic tests that are configured for a switch and the test results, use these privileged 
EXEC commands:

diagnostic start test {test-id | test-id-range | all | basic | 
non-disruptive}

Start a diagnostic test on a specific switch. 

Display the online diagnostics configured for a switch. 

Display whether a switch is running a test.

show diagnostic result  detail

show diagnostic result  test [test_id | test_id_range] [detail]

Display the online diagnostics test results.

Display the online diagnostics test schedule.

Display the results of POST. (The same as the show post 
command.)