Cisco Systems 3560 사용자 설명서
20-14
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
Chapter 20 Configuring Flex Links and the MAC Address-Table Move Update Feature
Monitoring Flex Links and the MAC Address-Table Move Update
To disable the MAC address-table move update feature, use the no mac address-table move update
receive configuration command. To display the MAC address-table move update information, use the
show mac address-table move update privileged EXEC command.
receive configuration command. To display the MAC address-table move update information, use the
show mac address-table move update privileged EXEC command.
This example shows how to configure a switch to get and process MAC address-table move update
messages:
messages:
Switch# configure terminal
Switch(conf)# mac address-table move update receive
Switch(conf)# end
Monitoring Flex Links and the MAC Address-Table
Move Update
Move Update
shows the privileged EXEC commands for monitoring the Flex Links configuration and the
MAC address-table move update information.
Step 4
show mac address-table move update
Verify the configuration.
Step 5
copy running-config startup config
(Optional) Save your entries in the switch startup
configuration file.
configuration file.
Command
Purpose
Table 20-1
Flex Links and MAC Address-Table Move Update Monitoring Commands
Command
Purpose
show interfaces [interface-id] switchport
backup
backup
Displays the Flex Link backup interface configured for an interface or all the
configured Flex Links and the state of each active and backup interface (up
or standby mode). When VLAN load balancing is enabled, the output
displays the preferred VLANS on Active and Backup interfaces.
configured Flex Links and the state of each active and backup interface (up
or standby mode). When VLAN load balancing is enabled, the output
displays the preferred VLANS on Active and Backup interfaces.
show mac address-table move update
Displays the MAC address-table move update information on the switch.