Cisco Systems 3560 사용자 설명서
C H A P T E R
23-1
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
23
Configuring IGMP Snooping and MVR
This chapter describes how to configure Internet Group Management Protocol (IGMP) snooping on the
Catalyst 3560 switch, including an application of local IGMP snooping, Multicast VLAN Registration
(MVR). It also includes procedures for controlling multicast group membership by using IGMP filtering
and procedures for configuring the IGMP throttling action.
Catalyst 3560 switch, including an application of local IGMP snooping, Multicast VLAN Registration
(MVR). It also includes procedures for controlling multicast group membership by using IGMP filtering
and procedures for configuring the IGMP throttling action.
Note
For IP Version 6 (IPv6) traffic, Multicast Listener Discovery (MLD) snooping performs the same
function as IGMP snooping for IPv4 traffic. For information about MLD snooping, see
function as IGMP snooping for IPv4 traffic. For information about MLD snooping, see
Note
For complete syntax and usage information for the commands used in this chapter, see the switch
command reference for this release and the “IP Multicast Routing Commands” section in the Cisco IOS
IP Command Reference, Volume 3 of 3:Multicast, Release 12.2 from the Cisco.com page under
Documentation > Cisco IOS Software > 12.2 Mainline > Command References.
command reference for this release and the “IP Multicast Routing Commands” section in the Cisco IOS
IP Command Reference, Volume 3 of 3:Multicast, Release 12.2 from the Cisco.com page under
Documentation > Cisco IOS Software > 12.2 Mainline > Command References.
This chapter consists of these sections:
•
•
•
•
•
•
•
•
Note
You can either manage IP multicast group addresses through features such as IGMP snooping and MVR,
or you can use static IP addresses.
or you can use static IP addresses.