Cisco Systems 3560 사용자 설명서

To return the switch to its default settings, use the no mvr [mode | group ip-address | querytime | vlan] 
global configuration commands.

This example shows how to enable MVR, configure the group address, set the query time to 1 second 
(10 tenths), specify the MVR multicast VLAN as VLAN 22, and set the MVR mode as dynamic:

Switch(config)# mvr

Switch(config)# mvr group 228.1.23.4

Switch(config)# mvr querytime 10

Switch(config)# mvr vlan 22 

Switch(config)# mvr mode dynamic 

Switch(config)# end 

You can use the show mvr members privileged EXEC command to verify the MVR multicast group 
addresses on the switch.

Beginning in privileged EXEC mode, follow these steps to configure Layer 2 MVR interfaces:

end 

Return to privileged EXEC mode.

show mvr or show mvr members

Verify the configuration.

copy running-config 
startup-config 

(Optional) Save your entries in the configuration file.

Enter global configuration mode.

mvr 

Enable MVR on the switch.

interface interface-id

Specify the Layer 2 port to configure, and enter interface configuration 
mode.

mvr type {source | receiver}

Configure an MVR port as one of these:

source—Configure uplink ports that receive and send multicast data as 
source ports. Subscribers cannot be directly connected to source ports. 
All source ports on a switch belong to the single multicast VLAN.

receiver—Configure a port as a receiver port if it is a subscriber port 
and should only receive multicast data. It does not receive data unless it 
becomes a member of the multicast group, either statically or by using 
IGMP leave and join messages. Receiver ports cannot belong to the 
multicast VLAN.

The default configuration is as a non-MVR port. If you attempt to configure 
a non-MVR port with MVR characteristics, the operation fails.