Cisco Systems 3560 사용자 설명서
36-29
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
Chapter 36 Configuring IP Unicast Routing
Configuring OSPF
Beginning in privileged EXEC mode, follow these steps to configure area parameters:
Use the no form of these commands to remove the configured parameter value or to return to the
default value.
default value.
Configuring Other OSPF Parameters
You can optionally configure other OSPF parameters in router configuration mode.
•
Route summarization: When redistributing routes from other protocols as described in the
, each route is advertised
individually in an external LSA. To help decrease the size of the OSPF link state database, you can
use the summary-address router configuration command to advertise a single router for all the
redistributed routes included in a specified network address and mask.
use the summary-address router configuration command to advertise a single router for all the
redistributed routes included in a specified network address and mask.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
router ospf process-id
Enable OSPF routing, and enter router configuration mode.
Step 3
area area-id authentication
(Optional) Allow password-based protection against unauthorized
access to the identified area. The identifier can be either a decimal
value or an IP address.
access to the identified area. The identifier can be either a decimal
value or an IP address.
Step 4
area area-id authentication message-digest (Optional) Enable MD5 authentication on the area.
Step 5
area area-id stub [no-summary]
(Optional) Define an area as a stub area. The no-summary keyword
prevents an ABR from sending summary link advertisements into the
stub area.
prevents an ABR from sending summary link advertisements into the
stub area.
Step 6
area area-id nssa [no-redistribution]
[default-information-originate]
[no-summary]
[default-information-originate]
[no-summary]
(Optional) Defines an area as a not-so-stubby-area. Every router
within the same area must agree that the area is NSSA. Select one of
these keywords:
within the same area must agree that the area is NSSA. Select one of
these keywords:
•
no-redistribution—Select when the router is an NSSA ABR and
you want the redistribute command to import routes into normal
areas, but not into the NSSA.
you want the redistribute command to import routes into normal
areas, but not into the NSSA.
•
default-information-originate—Select on an ABR to allow
importing type 7 LSAs into the NSSA.
importing type 7 LSAs into the NSSA.
•
no-redistribution—Select to not send summary LSAs into the
NSSA.
NSSA.
Step 7
area area-id range address mask
(Optional) Specify an address range for which a single route is
advertised. Use this command only with area border routers.
advertised. Use this command only with area border routers.
Step 8
end
Return to privileged EXEC mode.
Step 9
show ip ospf [process-id]
show ip ospf [process-id [area-id]] database
Display information about the OSPF routing process in general or for
a specific process ID to verify configuration.
a specific process ID to verify configuration.
Display lists of information related to the OSPF database for a
specific router.
specific router.
Step 10
copy running-config startup-config
(Optional) Save your entries in the configuration file.