Cisco Systems 3560 사용자 설명서
36-37
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
Chapter 36 Configuring IP Unicast Routing
Configuring EIGRP
Use the no forms of these commands to disable the feature or return the setting to the default value.
Configuring EIGRP Interfaces
Other optional EIGRP parameters can be configured on an interface basis.
Beginning in privileged EXEC mode, follow these steps to configure EIGRP interfaces:
Step 9
end
Return to privileged EXEC mode.
Step 10
show ip protocols
Verify your entries.
Step 11
show ip protocols
Verify your entries.
For NSF awareness, the output shows:
*** IP Routing is NSF aware ***
EIGRP NSF enabled
Step 12
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Command
Purpose
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface interface-id
Enter interface configuration mode, and specify the Layer 3
interface to configure.
interface to configure.
Step 3
ip bandwidth-percent eigrp percent
(Optional) Configure the percentage of bandwidth that can
be used by EIGRP on an interface. The default is 50 percent.
be used by EIGRP on an interface. The default is 50 percent.
Step 4
ip summary-address eigrp
autonomous-system-number address mask
autonomous-system-number address mask
(Optional) Configure a summary aggregate address for a
specified interface (not usually necessary if auto-summary is
enabled).
specified interface (not usually necessary if auto-summary is
enabled).
Step 5
ip hello-interval eigrp autonomous-system-number
seconds
seconds
(Optional) Change the hello time interval for an EIGRP
routing process. The range is 1 to 65535 seconds. The
default is 60 seconds for low-speed NBMA networks and 5
seconds for all other networks.
routing process. The range is 1 to 65535 seconds. The
default is 60 seconds for low-speed NBMA networks and 5
seconds for all other networks.
Step 6
ip hold-time eigrp autonomous-system-number
seconds
seconds
(Optional) Change the hold time interval for an EIGRP
routing process. The range is 1 to 65535 seconds. The
default is 180 seconds for low-speed NBMA networks and
15 seconds for all other networks.
routing process. The range is 1 to 65535 seconds. The
default is 180 seconds for low-speed NBMA networks and
15 seconds for all other networks.
Caution
Do not adjust the hold time without consulting
Cisco technical support.
Cisco technical support.
Step 7
no ip split-horizon eigrp autonomous-system-number (Optional) Disable split horizon to allow route information
to be advertised by a router out any interface from which that
information originated.
information originated.
Step 8
end
Return to privileged EXEC mode.