DELL 9.8(0.0) 사용자 설명서
Related
Command
Command
— sets the delay time for VRRP initialization after a line card
reboot.
vrrp-group
Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per interface.
Syntax
vrrp-group vrrp-id
Parameters
vrrp-id
Enter a number as the group ID. The range is from 1 to 255.
Defaults
Not configured.
Command
Modes
Modes
INTERFACE
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.2.1.1
Introduced on the E-Series.
Usage
Information
Information
The VRRP group only becomes active and sends VRRP packets when a virtual IP
address is configured. When you delete the virtual address, the VRRP group stops
sending VRRP packets.
address is configured. When you delete the virtual address, the VRRP group stops
sending VRRP packets.
Related
Command
Command
— assigns up to 12 virtual IP addresses per VRRP group.
IPv6 VRRP Commands
The following are IPv6 VRRP commands.
•
1904
Virtual Router Redundancy Protocol (VRRP)