Q-Logic 5800V 사용자 설명서

3–Installation

Installing a Switch

59265-02  B

3-7

If you plan to use the CLI to configure and manage the switch, you must configure 
the workstation. To configure the workstation, set the workstation IP address for 
Ethernet connections, or configure the workstation serial port. If you plan to use 
QuickTools or Enterprise Fabric Suite to manage the switch, the Configuration 
Wizard manages the workstation IP address for you—proceed to 

.

The default IP address of a new switch is 10.0.0.1. To ensure that your 
workstation is configured to communicate with the 10.0.0 subnet, refer to the 
following instructions for your workstation:

Do the following:

1.

Click the Start button and choose Settings, Control Panel, and then 
Network and Dial-Up Connections.

2.

Click Make New Connection.

3.

Click the Connect to a private network through the Internet radio button, 
and then click Next. 

4.

Type 10.0.0.253 for the IP address.

Open a command window and type the following command, where (interface) is 
your interface name:

ifconfig (interface) ipaddress 10.0.0.253 netmask 255.255.255.0 up

Do the following:

1.

Choose System Preferences, System Preferences, and then Network.

2.

Double-click your network adapter.

3.

In the configuration dialog, select Manually from the Configure IPv4 list.

4.

Type 10.0.0.253 in the IP Address field.

5.

Type 255.255.255.0 in the Subnet Mask field.

6.

Click Apply Now.