National Instruments PC-LPM-16/PnP 사용자 설명서

 

Appendix C     Using Your PC-LPM-16 (Non-PnP) Board

 



 

 National Instruments Corporation

C-7

PC-LPM-16/PnP User Manual

 

Each switch in U26 corresponds to one of the address lines A9 through 
A5. Slide the switch to the side labeled 

 

 to

 

 to select a binary value 

of 

 

 for the corresponding address bit. Slide the switch to the side of 

the switch labeled 

 

 to select a binary value of 

 

 for the 

corresponding address bit. Figure C-2 shows two possible switch 
settings. 

 

Example Base I/O Address Switch Settings

 

The PC-LPM-16 decodes the five LSBs of the address (A4 through A0)  
to select the appropriate PC-LPM-16 register. To change the base I/O 
address:

1.

Remove the plastic cover on U26. 

2.

Slide each switch to the desired position. 

3.

Check each switch to verify that the switch is pressed entirely to the 

side. 

4.

Replace the plastic cover. 

Note the new PC-LPM-16 base I/O address for use when configuring 
the PC-LPM-16 software in the 

 

 in Appendix E, 

 

–Slide to this side for 1

–Slide to this side for 0

a. Switches Set to Base I/O Address of Hex 000 

b. Switches Set to Base I/O Address of Hex 260 (Factory Setting)

U26

A9
A8
A7
A6
A5

–Slide to this side for 1

–Slide to this side for 0

U26

A9
A8
A7
A6
A5