Netgear GSM7228PS-100NAS 사용자 설명서
Switching Commands
112
ProSafe Managed Switch
dot1x supplicant timeout auth-period
Use this command to configure the authentication period timer interval to wait for the next
EAP request challenge from the authenticator.
EAP request challenge from the authenticator.
Default
Format
dot1x supplicant timeout auth-period <1-65535 seconds>
Mode
no dot1x supplicant timeout auth-period
Use this command to set the auth-period value to the default value.
Format
no dot1x supplicant timeout auth-period
Mode
dot1x supplicant user
Use this command to map the given user to the port.
Format
dot1x supplicant user
Mode
Storm-Control Commands
This section describes commands you use to configure storm-control and view storm-control
configuration information. A traffic storm is a condition that occurs when incoming packets
flood the LAN, which creates performance degradation in the network. The Storm-Control
feature protects against this condition.
configuration information. A traffic storm is a condition that occurs when incoming packets
flood the LAN, which creates performance degradation in the network. The Storm-Control
feature protects against this condition.
The 7000 series provides broadcast, multicast, and unicast story recovery for individual
interfaces. Unicast Storm-Control protects against traffic whose MAC addresses are not
known by the system. For broadcast, multicast, and unicast storm-control, if the rate of traffic
ingressing on an interface increases beyond the configured threshold for that type, the traffic
is dropped.
interfaces. Unicast Storm-Control protects against traffic whose MAC addresses are not
known by the system. For broadcast, multicast, and unicast storm-control, if the rate of traffic
ingressing on an interface increases beyond the configured threshold for that type, the traffic
is dropped.
To configure storm-control, you will enable the feature for all interfaces or for individual
interfaces, and you will set the threshold (storm-control level) beyond which the broadcast,
multicast, or unicast traffic will be dropped. The Storm-Control feature allows you to limit the
rate of specific types of packets through the switch on a per-port, per-type, basis.
interfaces, and you will set the threshold (storm-control level) beyond which the broadcast,
multicast, or unicast traffic will be dropped. The Storm-Control feature allows you to limit the
rate of specific types of packets through the switch on a per-port, per-type, basis.
Configuring a storm-control level also enables that form of storm-control. Disabling a
storm-control level (using the “no” version of the command) sets the storm-control level back
to the default value and disables that form of storm-control. Using the “no” version of the
“storm-control” command (not stating a “level”) disables that form of storm-control but
storm-control level (using the “no” version of the command) sets the storm-control level back
to the default value and disables that form of storm-control. Using the “no” version of the
“storm-control” command (not stating a “level”) disables that form of storm-control but
30 seconds
Interface Config
Interface Config
Interface Config