Netgear GSM7228PS-100NAS 사용자 설명서

no flowcontrol

• Global Config

• Interface Config

Use this command to display the IEEE 802.3 Annex 31B flow control settings and status for a 
specific interface or all interfaces. It also displays 802.3 Tx and Rx pause counts. Priority 
Flow Control frames counts are not displayed. If the port is enabled for priority flow control, 
operational flow control status is displayed as “Inactive”. Operational flow control status for 
stacking ports is always displayed as “N/A”. 

show flowcontrol [unit/slot/port]

Examples:

(switch)#show flowcontrol

Admin Flow Control: Symmetric

Port    Flow Control    RxPause    TxPause

        Oper                              

------  ------------    --------   ---------

0/1     Active          310        611      

0/2     Inactive        0          0      

                                   

(switch)#show flowcontrol interface 0/1

Admin Flow Control: Symmetric

Port       Flow Control  RxPause      TxPause

           Oper                              

---------  -------       --------     -------

0/1        Active        310          611  

Port-Channel/LAG (802.3ad) Commands

This section describes the commands you use to configure port-channels, which are also 
known as link aggregation groups (LAGs). Link aggregation allows you to combine multiple 
full-duplex Ethernet links into a single logical link. Network devices treat the aggregation as if 
it were a single link, which increases fault tolerance and provides load sharing. The LAG 
feature initially load shares traffic based upon the source and destination MAC 
address.Assign the port-channel (LAG) VLAN membership after you create a port-channel. If 
you do not assign VLAN membership, the port-channel might become a member of the 
management VLAN which can result in learning and switching issues.

Privileged Exec