Netgear GSM7228PS-100NAS 사용자 설명서

When you specify a value for vlanid, the following information appears.

When the optional argument detail is used, the command shows the global information 
and the information for all Querier-enabled VLANs.

Port Security Commands

This section describes the commands you use to configure Port Security on the switch. Port 
security, which is also known as port MAC locking, allows you to secure the network by 
locking allowable MAC addresses on a port. Packets with a matching source MAC address 
are forwarded normally, and all other packets are discarded. 

To enable the SNMP trap specific to port security, see 

Indicates whether MLD Snooping Querier is active on the VLAN.

Indicates whether MLD Snooping Querier is in “Querier” or “Non-Querier” state. When 
the switch is in Querier state, it will send out periodic general queries. When in 
Non-Querier state, it will wait for moving to Querier state and does not send out any 
queries.

Indicates the time to wait before removing a Leave from a host upon receiving a Leave 
request. This value is calculated dynamically from the Queries received from the 
network. If the Snooping Switch is in Querier state, then it is equal to the configured 
value.

Indicates whether the MLD Snooping Querier participates in querier election if it 
discovers the presence of a querier in the VLAN.

The IP address will be used in the IPv6 header while sending out MLD queries on this 
VLAN. It can be configured using the appropriate command.

This version of IPv6 will be used while sending out MLD queriers on this VLAN.

Indicates the IP address of the most recent Querier from which a Query was received.

Indicates the MLD version of the most recent Querier from which a Query was received 
on this VLAN.