Netgear GSM7228PS-100NAS 사용자 설명서

The commands in this chapter are in three functional groups:

Show commands display switch settings, statistics, and other information.

Configuration commands configure features and options of the switch. For every 

configuration command, there is a show command that displays the configuration setting.

Clear commands clear some or all of the settings to factory defaults.

Port Configuration Commands

This section describes the commands you use to view and configure port settings. 

This command gives you access to the Interface Config mode, which allows you to enable or 
modify the operation of an interface (port).

interface <unit/slot/port>

This command gives you access to the vlan virtual interface mode, which allows certain port 
configurations (for example, the IP address) to be applied to the VLAN interface. Type a 
question mark (?) after entering the interface configuration mode to see the available options.

interface vlan <vlan id>

This command gives you access to the LAG (link aggregation, or port channel) virtual 
interface, which allows certain port configurations to be applied to the LAG interface. Type a 
question mark (?) after entering the interface configuration mode to see the available options. 

Global Config

Global Config