Netgear GSM7228PS-100NAS 사용자 설명서
Switching Commands
47
ProSafe Managed Switch
Spanning Tree Protocol (STP) Commands
This section describes the commands you use to configure Spanning Tree Protocol (STP).
STP helps prevent network loops, duplicate messages, and network instability.
STP helps prevent network loops, duplicate messages, and network instability.
spanning-tree
This command sets the spanning-tree operational mode to enabled.
Default
Format
spanning-tree
Mode
no spanning-tree
This command sets the spanning-tree operational mode to disabled. While disabled, the
spanning-tree configuration is retained and can be changed, but is not activated.
spanning-tree configuration is retained and can be changed, but is not activated.
Format
no spanning-tree
Mode
spanning-tree auto-edge
This command enables auto-edge on the interface or range of interfaces. When enabled, the
interface becomes an edge port if it does not see BPDUs for edge delay time.
interface becomes an edge port if it does not see BPDUs for edge delay time.
Default
Format
spanning-tree auto-edge
Mode
no spanning-tree auto-edge
This command disables auto-edge on the interface or range of interfaces.
Format
no spanning-tree auto-edge
Mode
spanning-tree bpdufilter
Use this command to enable BPDU Filter on an interface or range of interfaces.
Default
Format
spanning-tree bpdufilter
Mode
enabled
Global Config
Global Config
enabled
Interface Config
Interface Config
disabled
Interface Config