Netgear GSM7228PS-100NAS 사용자 설명서

This command displays a MAC access list and all of the rules that are defined for the MAC 
ACL. Use the [name] parameter to identify a specific MAC ACL to display.

show mac access-lists [name]

IP Access Control List (ACL) Commands

This section describes the commands you use to configure IP ACL settings. IP ACLs ensure 
that only authorized users have access to specific resources and block any unwarranted 
attempts to reach network resources. 

The following rules apply to IP ACLs:

Managed switch software does not support IP ACL configuration for IP packet fragments.

The maximum number of ACLs you can create is hardware dependent. The limit applies 

to all ACLs, regardless of type.

The maximum number of rules per IP ACL is hardware dependent.

Wildcard masking for ACLs operates differently from a subnet mask. A wildcard mask is 

in essence the inverse of a subnet mask. With a subnet mask, the mask has ones (1's) in 
the bit positions that are used for the network address, and has zeros (0's) for the bit 

Privileged EXEC

The ordered rule number identifier defined within the MAC ACL.

The action associated with each rule. The possible values are Permit or Deny.

The source MAC address for this rule.

The destination MAC address for this rule.

The Ethertype keyword or custom value for this rule.

The VLAN identifier value or range for this rule.

The COS (802.1p) value for this rule.

Displays when you enable logging for the rule.

The queue identifier to which packets matching this rule are assigned.

The unit/slot/port to which packets matching this rule are copied.

The unit/slot/port to which packets matching this rule are forwarded.

Displays the name of the time-range if the MAC ACL rule has referenced a time range.

Status (Active/Inactive) of the MAC ACL rule