Netgear GS728TP100NAS 사용자 설명서

IP

The IP folder contains links to the following web pages that configure and display IP routing 
data:

Basic

From the Basic link, you can access the following pages:

Use this menu to configure routing parameters for the switch, as opposed to an interface. 

To display the IP Configuration page, click Routing









 IP Configuration.

To configure global IP routing:

Use Routing Mode to select enable or disable. You must enable routing for the switch 

before you can route through any of the interfaces. The default value is disable.

Use ICMP Echo Replies to select enable or disable. If it is enable then only the router can 

send ECHO replies. By default ICMP Echo Replies are sent for echo requests.

Use ICMP Redirects to select enable or disable. If it is enabled globally and on interface 

level then only the router can send ICMP Redirects.

Use ICMP Rate Limit Interval to control the ICMP error packets by specifying the number 

of ICMP error packets that are allowed per burst interval. By default, Rate limit is 100 

packets/sec i.e., burst interval is 1000 msec. To disable ICMP Rate limiting, set this field to 

'0'. Valid Rate Interval must be in the range 0 to 2147483647.