Netgear GS728TP100NAS 사용자 설명서

This page regulates new outbound telnet connections. If Allow New Telnet Sessions are 
enabled, new outbound telnet sessions can be established until there are no more sessions 
available. If Allow New Telnet Sessions are disabled, no new outbound telnet sessions are 
established. An established session remains active until the session is ended or an abnormal 
network error ends the session.

Use Allow New Telnet Sessions to specify whether the new Outbound Telnet Session is 

Enabled or Disabled. Default value is Enabled.

Use Maximum Number of Sessions to specify the maximum number of Outbound Telnet 

Sessions allowed. Default value is 5. Valid Range is (0 to 5).

Use Session Timeout to specify the Outbound Telnet login inactivity time-out. Default value 

is 5. Valid Range is (1 to 160).

Current Number of Sessions - Displays the number of current sessions.

Console Port

To display the Console Port page, click Security 



 Access > Console Port.

To configure console port settings:

Use Serial Port Login Timeout (minutes) to specify how many minutes of inactivity 

should occur on a serial port connection before the switch closes the connection. Enter 

a number between 0 and 160: the factory default is 5. Entering 0 disables the time-out.

Use Baud Rate (bps) to select the default baud rate for the serial port connection from the 

pull-down menu. You may choose from 1200, 2400, 4800, 9600, 19200, 38400, 57600, and 

115200 baud. The factory default is 9600 baud.

Use Login Authentication List to specify which authentication list to use when you login 

through Telnet. The default value is defaultList.

Use Enable Authentication List to specify which authentication list you are using when 

going into the privileged EXEC mode. The default value is enableList.