Netgear GS728TP100NAS 사용자 설명서
Maintenance
500
ProSafe M5300 Switch
•
InitTTL - Enter the initial TTL to be used. The initial value is default value. The InitTTL
you enter is not retained across a power cycle.
you enter is not retained across a power cycle.
•
MaxFail - Enter the maximum Failures allowed in the session. The initial value is
default value. The MaxFail you enter is not retained across a power cycle.
default value. The MaxFail you enter is not retained across a power cycle.
•
Interval(secs) - Enter the Time between probes in seconds. The initial value is default
value. The Interval you enter is not retained across a power cycle.
value. The Interval you enter is not retained across a power cycle.
•
Port - Enter the UDP Dest port in probe packets. The initial value is default value. The
port you enter is not retained across a power cycle.
port you enter is not retained across a power cycle.
•
Size - Enter the Size of probe packets. The initial value is default value. The Size you
enter is not retained across a power cycle.
enter is not retained across a power cycle.
3.
Click CANCEL to cancel the operation on the screen and reset the data on the screen to the
latest value of the switch.
4.
Click APPLY to initiate the traceroute. The results display in the TraceRoute area.
Traceroute IPv6
Use this screen to tell the switch to send a TraceRoute request to a specified IP address or
Hostname. You can use this to discover the paths packets take to a remote destination. Once
you click the APPLY button, the switch will send traceroute and the results will be displayed
below the configurable data.
Hostname. You can use this to discover the paths packets take to a remote destination. Once
you click the APPLY button, the switch will send traceroute and the results will be displayed
below the configurable data.
If a reply to the traceroute is received, you will see:
•
1 a:b:c:d:e:f:g 9869 usec 9775 usec 10584 usec
•
2 0:0:0:0:0:0:0:0 0 usec * 0 usec * 0 usec *
•
Hop Count = w Last TTL = z Test attempt = x Test Success = y.
To display the Traceroute IPv6 page, click Maintenance
Troubleshooting
Traceroute
IPv6.
1.
Use IPv6 Address/Hostname to enter the IPv6 address or Hostname of the station you
want the switch to discover path. The initial value is blank. The IPv6 Address or
Hostname you enter is not retained across a power cycle.
2.
Use Port to enter the UDP Dest port in probe packets. The initial value is default value. The
port you enter is not retained across a power cycle.
3.
Click APPLY to initiate the traceroute.