Netgear GS724TS-100NAS 사용자 설명서

Switch Discovery in a Network without a DHCP Server

This section describes how to use the Smart Control Center to set up your switch in a 
network without a DHCP server. If your network has no DHCP service, you must assign a 
static IP address to your switch. If you choose, you can assign it a static IP address, even if 
your network has DHCP service.

To assign a static IP address:

Connect the switch to your existing network.

Power on the switch by plugging in the AC-DC power adapter.

Install the Smart Control Center on your computer.

Start the Smart Control Center.

Click Discover for the Smart Control Center to find your GS716T and GS724T switch. The 

utility broadcasts Layer 2 discovery packets within the broadcast domain to discover the 

switch. You should see a screen similar to 

Select the switch, then click Configure Device. The page expands to display additional 

fields at the bottom of the page, as the following figure shows.

. 

Choose the Disabled radio button to disable DHCP.

Enter the static switch IP address, gateway IP address, and subnet mask for the switch, and 

then type your password.

You must enter the current password every time you use the Smart 

Control Center to update the switch setting. The default password is 
password.